Where does the time go?

Last week I was mostly preoccupied by aligning the reed switches to the magnets.  There is still more work to do on this.  The challenge is getting all the magnets the correct distance from their switch.  I am waiting for some nylon washers to arrive, which will allow me to raise individual magnets by 0.5mm at a time until I get the correct distance, but I suspect that one or two of the pedals will need a fraction shaving off the end to increase the distance when in the ‘off’ position.  Hysteresis is a harsh mistress.

Expecting the toe pistons to arrive next week, but there is quite a bit of cabinetry to be done on the kneeboard, to make them fit.  This will probably turn out to be the most complex part of the build.  Fortunately I have expert help.